Taking a responsible approach to water efficiency doesn't need to be difficult. Simple changes in everyday habits can save a lot of water.
Follow these tips to see how small changes can make a big difference to your water use.
You don’t need to use large amounts of water to keep your car and driveway clean. Waterless and water efficient car washes and high pressure cleaners mean you can clean the car and be water efficient.
- The average hose with a trigger or twist nozzle uses 15 to 20 litres of water a minute.
- Use a bucket of soapy water or a high pressure cleaning unit to wash your car at home. This can save 8 litres of water a minute.
- Wash your car on the grass so runoff can water your lawn.
- Commercial car washing facilities use recycling systems which capture, clean and reuse the wash water to maximise water efficiency.
- Use a pool cover to reduce evaporation by up to 90 percent and save up to 36,000 litres of water a year. Covering the pool lowers the water temperature, decreases evaporation and stops debris falling in the pool.
- Increase shade over the pool to help reduce evaporation.
- Landscape around the pool with walls and hedges to create shelter from the wind. This will help to reduce water loss.
- Top up your swimming pool with tank water or a rainwater diverter. Rainwater diverters attached to a downpipe will divert rainwater into your swimming pool.
- Consider keeping the water level several centimetres lower to prevent water spillage. Swimming and splashing can result in a lot of water being spilled over the edge.
- Check the weather forecast before topping up your pool. If rain is forecast, let nature top it up for you!
Check your swimming pool for leaks
Loss of pool water can be caused by exposure to the sun and wind, water temperature, humidity and leaks. To find out if you have a leak:
- Check for bubbles in the return lines when the pool pump is running. If there are bubbles, there may be a leak in the suction side of the filtration system.
- Check the waste or backwash line for running water. If a pool is losing water while the pump is running, the leak may be on the return-line side of the system.
- Check for cracks, gaps or tears, skimmer leaks are the most common leaks in pools. They are caused by a separation between the plastic skimmer and the concrete pool. It will look like a crack, gap or tear and is easily repaired with pool putty.
- Check for leaks on the shell of the pool, in the lights, along tile lines, and in the pump and filter.
How to do a bucket test to check for pool leaks
A bucket test exposes water in a bucket to the same conditions as the pool. By comparing water loss in each you can determine if the pool is leaking or if water loss is due to other conditions like exposure to wind.
- Make sure the pool is filled to its normal level.
- Fill a bucket with pool water, leaving about 3 centimetres clear at the top of the bucket.
- Place the bucket on the first step of the pool.
- Mark the water level on the inside of the bucket.
- Shut off your pool pump.
- Mark the water level on the outside of the bucket.
- Turn the pool pump back on and run it as normal for 24 hours.
- After 24 hours, compare the two levels.
If the pool water level on the outside of the bucket is lower than the water level mark on the inside of the bucket, it is possible you have a leak. Perform the test again to confirm this.
If it rains or if the water levels are checked after a 24 hour period you will need to start the test again.
For best results, make sure you don’t use the swimming pool during the 24 hour test as splashing might confuse the results. Avoid doing the test of very windy days.
Water meters can help detect water leaks on your property. For more information about checking for leaks see Water leaks
For more ideas on how to save water in and around the home, visit the Blue House website.