Frequently asked questions - Fire hydrant flow testing

Fire hydrants are fittings that form part of our water supply network. They are installed and maintained by Council. Hydrants allow the Queensland Fire and Emergency Services to access water in the event of a fire or emergency incident

Hydrants are typically located along the edge of the street and are marked by a yellow lid, and a blue ‘cat’s eye’ reflector in the road. They are level with the ground.

As part of the testing, we need to release water from the hydrant. During this time, residents may notice a slight drop in their water pressure. This should return to its previous level after the testing. We apologise for any inconvenience.

During the testing, Logan Water and/or its representatives will be wearing branded uniforms and vehicles should also be branded. If you are concerned about the illegal use of fire hydrants, please phone Logan Water Community Engagement team on 07 2899 7457.

No. Water to your property will not be turned off during planned fire hydrant flow testing.

The estimated time for flow testing (release of water) on each hydrant can be one to three minutes. The testing time will vary depending on the condition of the fire hydrant, this can sometimes take up to 10 minutes.

All water discharged during testing will be discharged into the stormwater network. Unfortunately, capturing the water is not cost-effective. We will try to minimise water discharge where possible.

We test fire hydrants to ensure they are operating effectively for fire-fighting. As part of the testing, we need to release water to make sure the fire hydrant pressure is correct. We appreciate the community’s concern about using water in this way. However, the testing is essential to ensure our hydrants provide emergency service crews with the correct water pressures and flow rates for fire-fighting

Fire hydrants are connected to the potable (drinking) water supply. Following the testing of fire hydrants, it is important to check the cleanliness of your water before operating washing machines or filling kettles.

Run a tap closest to your water meter until the water runs clear – this may take a few minutes.

If you have any concerns about the quality of your water following the works, please contact us on 07 3412 3412.